Page 83 - Catalogo_Acessorios_RZR_2021

FOR THE LIFE POLARIS ENGINEERS PARTS THAT PUSH THE LIMITS PARTS & GARAGE

WITHOUT SACRIFICING STRENGTH AND DURABILITY. We build
OF YOUR RIDE our products so anyone with the right tools can maintain their vehicle from
their own garage - and get them back on the trails where they belong.

AIR FILTERS DRIVE BELTS MAINTENANCE
MAINTENANCE A clogged air filter can restrict air Polaris Engineered belts deliver unmatched performance for your off-road
flow to the engine leading to
vehicle. Developed and tested on all our engines for all environments and
MAINTENANCE
TIP reduced engine performance, conditions. Check your belt for delamination, hour glassing and glazing.
engine life or catastrophic failure.
BREAK-IN PERIOD
• Use lower gear (if available) while varying speeds and avoiding wide open
throttle for 8-16 km
BREAK-IN PERIOD • If no low gear is available, vary at moderate speeds while avoiding wide
open throttle for 80 km OIL & LUBRICANTS
The break-in period for your new
RZR is the first 25 hours of OUR INVESTMENT YOUR ADVANTAGE
operation, or the time it takes to BRAKE PADS • 32,187 km • No clutch recalibration
use the first two tanks of fuel. No of field testing • Less wear & tear due to heat
single action on your part is as Maintaining and/or replacing brakes • Thousands of dyno hours
important as a proper break-in are critical to the safety and • 18+ months of development • Ensure maximum vehicle
performance
period. Careful treatment of a functionally of a vehicle. Brake pads (13,000+ design hours) per belt
new engine will result in more should be checked for wear and oil or • 1,500+ vehicle validation hours • More time riding, less time wrenching SERVICE PARTS
grease (petroleum products)
efficient performance and longer contamination and brake discs should • Produced in collaboration with
life for the engine. be checked for cracks, excessive • Collaboration with powertrain powertrain and clutch engineers to
corrosion or warping. & clutch engineers ensure a perfect fit, maximum
performance and ultimate durability
NOTICE: Excessive heat build-up during the
first three hours of operation will damage
close-fitted engine parts. Do not operate at
full throttle or high speeds for extended
periods during the first three hours of use. HD PARTS
HALF SHAFT OIL FILTERS
Check for tear and punctures in the BATTERIES Change oil filters with every oil
boot which can lead to CV joint wear change to provide the best engine
that can contribute to axle failure. protection and keep the engine
To ensure a battery maintains its level of & TRAILERING
charge when unused for extended periods of operating at peak performance. VEHICLE CARE
time or during freezing weather, the battery
should be connected to a suitable battery
charger. Consult your dealer to ensure the
charger is compatible with your vehicle.
FOLLOW RECOMMENDED SERVICE
INTERVALS IN THE OWNER'S MANUAL

MAINTENANCE SCHEDULE

25 HRS / 400 km 50 HRS / 800 km 100 HRS / 1600 km 150 HRS / 2400 km 200 HRS / 3200 km 250 HRS / 4023 km 300 HRS / 4828 km
BREAK-IN 6 12 18 24 30 36 CHECK YOUR
OWNER'S MANUAL
MAINTENANCE FOR ADDITIONAL
MONTHS MONTHS MONTHS MONTHS MONTHS MONTHS RECOMMENDED
SERVICE ITEMS
ENGINE OIL: EXHAUST SYSTEM: ENGINE OIL: ENGINE OIL: ENGINE OIL: ENGINE OIL: ENGINE OIL:
CHANGE INSPECT & CLEAN CHANGE CHANGE CHANGE CHANGE CHANGE AND VEHICLE-
INSPECT FOR LEAKAGE OR SPECIFIC TIMING
GENERAL CARBON BUILD UP AT JOINTS DRIVE BELT: BATTERY: SHOCK OIL & SEALS BATTERY: AIR FILTER:
LUBRICATION: INSPECT & CLEAN SCREEN INSPECT & ADJUST TEST, CLEAN, & INSPECT TEST, CLEAN, & INSPECT & REPLACE
ALL FITTINGS, PIVOTS, TYPE SPARK ARRESTOR REPLACE AS NEEDED CHECK FLUID LEVEL REPLACE AS NEEDED CHECK FLUID LEVEL AS NEEDED
CABLES, ETC. REPLACE AS NEEDED REPLACE AS NEEDED
GENERAL TRANSMISSION BRAKE PADS & FLUID: GEARCASE &
AIR FILTER: LUBRICATION: FLUID: DRIVE BELT: REPLACE BRAKE FLUID DRIVE BELT: TRANSMISSION:
INSPECT & REPLACE ALL FITTINGS, CHANGE INSPECT & ADJUST INSPECT & ADJUST REPLACE FLUIDS
AS NEEDED PIVOTS, CABLES, ETC. REPLACE AS NEEDED SPARK PLUGS: REPLACE AS NEEDED
AIR FILTER: INSPECT EXHAUST SYSTEM:
EXHAUST SYSTEM: DRIVE BELT: INSPECT & REPLACE TIRES: REPLACE AS NEEDED GENERAL INSPECT & CLEAN
INSPECT & CLEAN INSPECT & ADJUST AS NEEDED INSPECT CONDITION LUBRICATION: INSPECT FOR LEAKAGE OR
INSPECT FOR LEAKAGE OR REPLACE AS NEEDED & PRESSURE AIR FILTER: ALL FITTINGS, CARBON BUILD UP AT JOINTS
CARBON BUILD UP AT JOINTS FRONT DRIVE FLUID INSPECT & REPLACE PIVOTS, CABLES, ETC.
EXHAUST SYSTEM: AS NEEDED INSPECT & CLEAN SCREEN
INSPECT & CLEAN SCREEN CHANGE TYPE SPARK ARRESTOR
TYPE SPARK ARRESTOR INSPECT & CLEAN EXHAUST SYSTEM:
INSPECT FOR LEAKAGE OR INSPECT & CLEAN
CARBON BUILD UP AT JOINTS EXHAUST SYSTEM: INSPECT FOR LEAKAGE OR
INSPECT & CLEAN CARBON BUILD UP AT JOINTS
INSPECT & CLEAN SCREEN INSPECT FOR LEAKAGE OR
TYPE SPARK ARRESTOR CARBON BUILD UP AT JOINTS INSPECT & CLEAN SCREEN
TYPE SPARK ARRESTOR
INSPECT & CLEAN SCREEN TYPE
SPARK ARRESTOR
80 81
80