Page 38 - General_Catalogo_Acessorios_2021

FOR THE LIFE POLARIS ENGINEERS PARTS THAT PUSH THE PARTS & GARAGE
LIMITS WITHOUT SACRIFICING STRENGTH

AND DURABILITY. We build our products so anyone with
OF YOUR RIDE the right tools can maintain their vehicle from their own
garage - and get them back on the trails where they belong.

AIR FILTERS DRIVE BELTS
MAINTENANCE A clogged air filter can restrict air Polaris Engineered belts deliver unmatched performance for your off-road MAINTENANCE
TIP flow to the engine leading to vehicle. Developed and tested on all our engines for all environments and
MAINTENANCE
conditions. Check your belt for delamination, hour glassing and glazing.
reduced engine performance,
engine life or catastrophic failure.
BREAK-IN PERIOD
• Use lower gear (if available) while varying speeds and avoiding wide open
BREAK-IN PERIOD throttle for 8-16 km
• If no low gear is available, vary at moderate speeds while avoiding wide
The break-in period for your new open throttle for 80 km OIL & LUBRICANTS
GENERAL is the first 25 hours of
operation, or the time it takes to
use the first two tanks of fuel. No OUR INVESTMENT YOUR ADVANTAGE
single action on your part is as BRAKE PADS
important as a proper break-in • 32,187 km of field testing • No clutch recalibration
period. Careful treatment of a Maintaining and/or replacing brakes • Thousands of dyno hours • Less wear & tear due to heat
new engine will result in more are critical to the safety and • 18+ months of development • Ensure maximum vehicle SERVICE PARTS
efficient performance and longer functionally of a vehicle. Brake pads (3,000+ design hours) per belt performance
life for the engine. should be checked for wear and oil or • 1200+ vehicle validation hours • More time riding, less time
grease (petroleum products)
contamination and brake discs should • Collaboration with powertrain wrenching
NOTICE: Excessive heat build-up during the be checked for cracks, excessive & clutch engineers • Produced in collaboration with
first three hours of operation will damage corrosion or warping. powertrain and clutch engineers to
close-fitted engine parts. Do not operate at ensure a perfect fit, maximum
full throttle or high speeds for extended performance and ultimate durability
periods during the first three hours of use. HD PARTS

OIL FILTERS
Change oil filters with every oil
BATTERIES change to provide the best engine
HALF SHAFT protection and keep the engine
To ensure a battery maintains its level of operating at peak performance. & TRAILERING
Check for tear and punctures in the charge when unused for extended VEHICLE CARE
boot which can lead to CV joint wear periods of time or during freezing
that can contribute to axle failure. weather, the battery should be
connected to a suitable battery charger.
Consult your dealer to ensure the
charger is compatible with your vehicle.
FOLLOW RECOMMENDED SERVICE
INTERVALS IN THE OWNER'S MANUAL

MAINTENANCE SCHEDULE

25 HRS / 400 km 50 HRS / 800 km 100 HRS / 1600 km 150 HRS / 2400 km 200 HRS / 3200 km 250 HRS / 4023 km 300 HRS / 4828 km
BREAK-IN 6 12 18 24 30 36 CHECK YOUR
OWNER'S MANUAL
MAINTENANCE FOR ADDITIONAL
MONTHS MONTHS MONTHS MONTHS MONTHS MONTHS RECOMMENDED
SERVICE ITEMS
ENGINE OIL: EXHAUST SYSTEM: ENGINE OIL: ENGINE OIL: ENGINE OIL: ENGINE OIL: ENGINE OIL: AND VEHICLE-
CHANGE INSPECT & CLEAN CHANGE CHANGE CHANGE CHANGE CHANGE SPECIFIC TIMING
INSPECT FOR LEAKAGE OR
GENERAL CARBON BUILD UP AT JOINTS DRIVE BELT: BATTERY: BRAKE PADS & FLUID: BATTERY: AIR FILTER:
LUBRICATION: INSPECT & CLEAN SCREEN INSPECT & ADJUST TEST, CLEAN, & INSPECT & CLEAN TEST, CLEAN, & INSPECT & REPLACE
ALL FITTINGS, PIVOTS, TYPE SPARK ARRESTOR REPLACE AS NEEDED CHECK FLUID LEVEL REPLACE BRAKE FLUID CHECK FLUID LEVEL AS NEEDED
CABLES, ETC. REPLACE AS NEEDED REPLACE AS NEEDED REPLACE AS NEEDED
GENERAL TRANSMISSION GEARCASE &
AIR FILTER: LUBRICATION: FLUID: DRIVE BELT: SPARK PLUGS: DRIVE BELT: TRANSMISSION:
INSPECT & REPLACE ALL FITTINGS, CHANGE INSPECT & ADJUST INSPECT INSPECT & ADJUST REPLACE FLUIDS
AS NEEDED PIVOTS, CABLES, ETC. REPLACE AS NEEDED REPLACE AS NEEDED REPLACE AS NEEDED
AIR FILTER: EXHAUST SYSTEM:
EXHAUST SYSTEM: DRIVE BELT: INSPECT & REPLACE TIRES: AIR FILTER: GENERAL INSPECT & CLEAN
INSPECT & CLEAN INSPECT & ADJUST AS NEEDED INSPECT CONDITION INSPECT & REPLACE LUBRICATION: INSPECT FOR LEAKAGE OR
INSPECT FOR LEAKAGE OR REPLACE AS NEEDED & PRESSURE AS NEEDED ALL FITTINGS, CARBON BUILD UP AT JOINTS
CARBON BUILD UP AT JOINTS EXHAUST SYSTEM: PIVOTS, CABLES, ETC.
EXHAUST SYSTEM: INSPECT & CLEAN SCREEN
INSPECT & CLEAN SCREEN INSPECT & CLEAN EXHAUST SYSTEM: TYPE SPARK ARRESTOR
TYPE SPARK ARRESTOR INSPECT FOR LEAKAGE INSPECT & CLEAN INSPECT & CLEAN EXHAUST SYSTEM:
OR CARBON BUILD UP AT INSPECT FOR LEAKAGE OR INSPECT & CLEAN
INSPECT FOR LEAKAGE OR
JOINTS CARBON BUILD UP AT JOINTS CARBON BUILD UP AT JOINTS INSPECT FOR LEAKAGE OR
CARBON BUILD UP AT JOINTS
INSPECT & CLEAN SCREEN INSPECT & CLEAN SCREEN
TYPE SPARK ARRESTOR TYPE SPARK ARRESTOR INSPECT & CLEAN SCREEN
TYPE SPARK ARRESTOR INSPECT & CLEAN SCREEN
TYPE SPARK ARRESTOR
36 37
37